Câble de connexion Amewi 28097 noir rouge jaune

The Amewi 28097 connector cable Black Red Yellow is a purpose-built wiring accessory for radio-controlled models. Designed to link servos, receivers, batteries, and other onboard electronics, this cable combines black, red and yellow conductors that allow clear phase and polarity identification during installation. The construction emphasizes reliable electrical contact and sufficient mechanical flexibility for routing inside model airframes, cars, or boats.

Advantages

The three-colour conductor layout simplifies connection and reduces wiring errors when assembling or servicing RC components. The cable offers straightforward compatibility with common connector housings used in hobby-grade radio control systems. Its flexible insulation and compact conductor arrangement facilitate neat cable routing in confined spaces while maintaining consistent signal and power transmission.

Suitable for

• Connecting servos to receivers in RC aircraft, cars, and boats
• Linking battery leads and power distribution modules when colour-coded wiring is required
• Replacing or extending existing three-wire connections in radio-control systems

Key specifications

• Three-conductor cable with black, red and yellow insulation for easy identification
• Designed for low-voltage DC signal and power transmission typical in radio-controlled models
• Flexible insulation suitable for routing through tight spaces in model assemblies

How to use

Cut the cable to the required length and strip the conductor ends to the appropriate length for your connector type. Match the black, red and yellow conductors to the corresponding pins on servos, receivers, or power modules, ensuring correct polarity and signal orientation. Use suitable crimp terminals or solder joints and apply heat-shrink tubing or insulating tape to secure and protect connections. Route the cable to avoid sharp bends and moving parts, fastening it with cable ties or clamps where necessary.

Recommendations

Verify compatibility with your model's connectors before installation and perform a continuity and polarity check with a multimeter after assembly. Avoid exposing the cable to prolonged moisture or chemical solvents to preserve insulation integrity.