Carte riser PCI Express x1 vers x16 DeLOCK 41430

The DeLOCK Riser Card PCI Express x1 to x16 (model 41430) enables mounting a PCIe x16 card in a different position inside the PC by plugging the riser into any PCI Express x1 slot on the motherboard. The riser uses a 60 cm cable and supports PCIe data transfer rates up to 0.8 Gbit/s. Its compact dimensions (128.2 mm x 43.5 mm x 21.2 mm) and black/blue/grey design allow flexible installation while conserving space inside the case.

Advantages

This riser card permits installation of a full-size PCI Express x16 graphics card where direct mounting is impractical due to space or slot-width constraints. By relocating the x16 slot, it supports operation of graphics cards in any available PCIe slot and, when multiple risers are used, enables several graphics cards to run simultaneously on one motherboard. The included 60 cm cable provides flexible positioning of the card within the chassis.

Suitable for

• Installing a PCIe x16 graphics card in a different case location
• Systems with limited adjacent slot space or tall components
• Multi-GPU setups such as mining rigs requiring several GPUs
• Compact or custom PC builds where board layout prevents direct mounting

Key specifications

• Model: DeLOCK 41430
• Interface: PCI Express x1 (host) to PCI Express x16 (device)
• Cable length: 60 cm
• Maximum data rate: 0.8 Gbit/s
• Dimensions: 128.2 x 43.5 x 21.2 mm
• Colour: black / blue / grey
• Brand: DELOCK
• MPN: 41430
• EAN: 4043619414307

How to use

Insert the riser card connector into an available PCI Express x1 slot on the motherboard. Mount the PCI Express x16 slot end in the desired location inside the case and secure it according to your chassis mounting points. Connect the graphics card to the x16 slot on the riser, ensure all power cables required by the GPU are connected, and verify that the system recognises the card during boot. If multiple risers are used, repeat the procedure for each card and check motherboard lane and power requirements.

Recommendations

Use the riser in systems where physical slot spacing or card width prevents direct installation. Ensure stable power delivery to each GPU and verify compatibility with your motherboard and graphics card. Keep cable runs tidy and avoid tight bends in the 60 cm cable to maintain signal integrity.